It needs to be made from correct thickness sheetmetal which is 2mm and it must have those pressings.
Total length is 1285mm or so.
There is 1.2mm version on the market but is thin compared to original..
Chassis tunnel bottom plate
Chassis tunnel bottom plate
Is there a person / company that can make chassis tunnel bottom plate?
It needs to be made from correct thickness sheetmetal which is 2mm and it must have those pressings.
Total length is 1285mm or so.
There is 1.2mm version on the market but is thin compared to original..
It needs to be made from correct thickness sheetmetal which is 2mm and it must have those pressings.
Total length is 1285mm or so.
There is 1.2mm version on the market but is thin compared to original..
Re: Chassis tunnel bottom plate
Hi Alex,
I don’t know any supplier, but mine was replaced by a German Workshop called GWD (tel: +49 211 283 147). They are well known in the German beetle community and very friendly people. I’m sure they can help you finding a good supplier if you give them a call.
Best regards
Pablo
I don’t know any supplier, but mine was replaced by a German Workshop called GWD (tel: +49 211 283 147). They are well known in the German beetle community and very friendly people. I’m sure they can help you finding a good supplier if you give them a call.
Best regards
Pablo
- 12.jpg (229.12 KiB) 1370 mal betrachtet